2000 Series Model LED Explosion-Proof LED Warning Light

Request Information

Pause

Features

  • Super bright output with XLT Technology
  • Three remotely selectable flash patterns
  • 50,000 hour lamp life
  • Available in five colors
  • Ex 'e' terminal chamber available
  • AC and DC voltage ranges
  • Approved for use in Zone 1, 2, 21, 22 atmospheres

The 2000 Series model LED beacon, with XLT technology, is a visual signal warning light for use in hazardous locations requiring ATEX approval. The beacon can produce three light patterns depending on the configuration of a field selectable jumper wire or remote contact closure. The light patterns are: steady-on, slow flash and rapid flash. An optional telephone initiation feature also allows the beacon to flash when telephone ringing voltage is present.

The 2000 Series LED beacon is sealed from dust and water by a nitrile rubber o-ring seal. All exterior cast aluminum surfaces are finished in powder coat paint and external hardware is manufactured from stainless steel to resist corrosion. Available signal colors are amber, blue, green, red and yellow.

The 2000 Series LED beacon is externally powered by 24VDC or 110-240VAC source. All AC powered units feature a switch mode power supply that accommodates a wide input voltage range without requiring any additional configuration from the user. The current consumption from the beacon is less than 500 mA and the in-rush current is low enough to allow PLC initiation without the use of an external relay. Screw type terminal blocks are provided for field wiring on all units.

All variations of the 2000 Series LED beacon feature a four entry fixture to allow cable looping. These cable entries are metric M20 X 1.5, but other configurations are available upon request.

Instruction sheets